Metal Type: Home | Library | Forum | Free Ads | Store

Author Topic: Ludlow sticking slug problem  (Read 226 times)

0 Members and 1 Guest are viewing this topic.

John B Easson

  • Apprentice
  • ***
  • Posts: 12
  • 03/03/2009
Ludlow sticking slug problem
« on: July 21, 2017, 05:39:09 PM »
My creaking and just operational Ludlow has a problem with the slugs sticking in the mats. I then have to extract the stick with slug attached, and break the slug to free the mats. I'm not sure why this is happening - is it temperature, pressure, dirty mats (they don't look bad, but haven't been used for ages)? It happens with large and small sizes. The metal in the pot is a mixture of scrap, not proper fresh ingots.
My book of troubleshooting solutions covers lots of topics, but not this one.



John Cornelisse

  • Son of Ottmar
  • ******
  • Posts: 129
  • 31/10/2014
Re: Ludlow sticking slug problem
« Reply #1 on: July 21, 2017, 08:26:36 PM »
It looks that the metal could be a factor...

Metal for line casting machines, like Lino- & Intertype & Ludlow used an alloy near 4-8 Sn/An.

This alloy solidifies rather quick as a whole, at one define temperature, and the cristals the slug inside are rather small.

Whenever possible, it would be wise to use clean new lead bars.

Mechanic

  • Moderator
  • *****
  • Posts: 586
  • Linotype Mechanic
  • 28/05/2007
    • LINOTYPE
Re: Ludlow sticking slug problem
« Reply #2 on: July 23, 2017, 05:23:07 AM »
Have a look at this maintenance sheet from Dave Seat.


http://www.hotmetalservices.com/Documents/JIMS%20-%20LUDLOW%20MAINTENANCE%20SCHEDULE.pdf

Visit his site
http://www.hotmetalservices.com/
He has a contact email address. People I know say he is very cooperative.

Although I've worked on Ludlows I'm no expert.
George Finn (Mechanic)
Gold Coast
Queensland
AUSTRALIA

John B Easson

  • Apprentice
  • ***
  • Posts: 12
  • 03/03/2009
Re: Ludlow sticking slug problem
« Reply #3 on: July 24, 2017, 12:36:56 PM »
Many thanks for those replies, I'll follow them up, though I fear Dave Seat would have apoplexy if he saw the state of my machine, never mind found out what my maintenance schedule was (or isn't). As to the metal, dropping my digital camera in the pot a few months ago may not have helped the alloy content: it certainly didn't do the camera any good. (I was videoing the process of casting.)

Dave Hughes

  • Administrator
  • *****
  • Posts: 1019
  • 21/06/2006
Re: Ludlow sticking slug problem
« Reply #4 on: July 24, 2017, 12:59:22 PM »
Glad you managed to find some help John.

Sorry to hear about your camera. Was the camera still filming when it dropped in the pot? Could make a good "blooper" video!
Exclusive Letterpress Gifts - Visit the Metal Type Zazzle Store